NextPVR Forums

NextPVR Forums > Public > Hardware > Cinergy Hybrid T USB XS
Full Version: Cinergy Hybrid T USB XS
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Ecthelion

2006-03-18, 12:31 PM
Hi,

I did not find any bda.ini setting for the Cinergy Hybrid T USB XS card. Using graphedit, I found out that the following entry should probably be the right one:

[Cinergy Hybrid T USB XS (Digital)]
TUNING_TYPE=DVB-T
FILTER_TUNER=Cinergy Hybrid T USB XS Tuner
FILTER_CAPTURE=Cinergy Hybrid T USB XS (Digital)
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

I then used "DVB EPG Broadcard" as EPG source as the card should support this (at least it does when using the Terratec software). But when using "Update EPG", a window pops up for a short moment and no channels are found. Also, when using "Map digital channels to EPG channels", the scanning process runs for quite some time and then returns without any channels being found. I noticed that there sometimes were channels where the Strength was >0 but the quality was always 0.

Can anyone give me a hint on how to get the card work? I have attached the log files in case they help in finding the problem. Thx

sub

2006-03-18, 04:53 PM
Can you try running the 'ReRegister filters.bat' file included with GB-PVR, then try again?

Ecthelion

2006-03-18, 05:56 PM
That did the job, thanks!
NextPVR Forums > Public > Hardware > Cinergy Hybrid T USB XS