Configuring two tuners on one board ATi Wonder 650

[jackk]

I am attempting to configure the ATI Wonder 650 which has both an analog and HD tuner on one board. I have listed them both, one as a BDA and the other as A Direct Recording Device in the capture device tab. Both work, but I have no control over which one is working at any one time. I unually start ATI's Catalyst, and change it there, but that doesn't always work. Generally the HD takes preference. Is there another screen, or plugin that will give me control in GBPVR over which one is active?

Thanks

[sub]

When you schedule a recording GB-PVR works its way down the capture source list (in order shown in config app), looking for a capture source that has the specified channel, and is available at the specified time.

When you start live tv, it does the opposite, working its way up from the bottom of the list.

[jackk]

Probably like most peole, all of my HD stations will be repeated in my analog list...unless I specifically delete them from one or the other.

I have my analog device listed first, so when I record it will always be analog.

When I want to watch TV, it will always be HD if I have the same station on both lists

I have not gotten into Chase TV yet, but I would guess that it starts by recording a progam and then playing it back a bit later. How will that work?

If I want to have total control, I may have to go with two boards instead of this ATI 650. That will not be too hard of a decision considering the support that I have gotten from ATI!

Thanks again