Combining CATV and antenna

[Hotaru]

I normally use cable service, but three area stations are not on my local cable service (one actually dropped in 2005). I have a switch that takes the CATV feed and the antenna in then sends the selected signal out.

Now, is it possible to set up GB-PVR with two PVR350 profiles, one for cable and one for antenna, along with two Zap2It sets of listings?

[stefan]

Well, you can at least do the same thing when using two different inputs on the pvr350 (one using coax, and the other one using s-video), so I'd say there's a big chance you can do what you want. Try it

Set up two different capture sources with the settings you want for EPG. Make sure you set the board number to #1 on both capture sources.

[dgeezer]

Hotaru,

If you are in the US and looking to buy a card for your pc you may want to look at the HVR1600 from Hauppauge. It combines a ATSC tuner and an analog cable tuner on one card. http://www.hauppauge.com/pages/products/...r1600.html

Stefan,

If I had read this post "Make sure you set the board number to #1 on both capture sources." before I installed this card it would have saved me hours of cursing and pulling out my hair.........

[stefan]

Stefan,

If I had read this post "Make sure you set the board number to #1 on both capture sources." before I installed this card it would have saved me hours of cursing and pulling out my hair.........

*smile* Knowledge comes with experience

[stefan]

By the way, this post was not here before you installed your card

[Hotaru]

Hotaru,

If you are in the US and looking to buy a card for your pc you may want to look at the HVR1600 from Hauppauge. It combines a ATSC tuner and an analog cable tuner on one card.

I already have a year-old PVR350. I will probably upgrade eventually, maybe Q3 '08.