Volume OSD, config how much VOL+ and VOL- changes volume

[Wakalaka]

I have the Volume OSD plugin installed, and am trying to figure out where I can change how much the VOL+ and VOL- changes the volume. I've found it before, but for the life of me can't find it again. It's set to 5% change right now, and I want it lower so I can have finer granularity control of volume.

[fla]

I've worked on the Volume OSD plugin before and from what I know it's only a display plugin. It gets called once a second by gbpvr and displays the current volume when it is on. It is not involved in changing the volume. If you set your volume to gbpvr internal or windows master volume etc the number of volume steps may be different for each config.

[McBainUK]

I've worked on the Volume OSD plugin before and from what I know it's only a display plugin.

This is correct, it was done before GB-PVR had a built-in volume OSD.

Volume change is mostly based on your setup. If your remote changes the windows master volume there might be a windows utility to adjust this. Google it

[Wakalaka]

Is the 5% setting I'm at right now a GB-PVR issue, Volume OSD, or something else? I know I changed it from 2% to 5%, and if memory serves me right, it was either GB-PVR or Volume OSD, although I can't find what on either.

[fla]

For sure the volume plugin only "looks at"/reads the current volume and displays it. There's nothing in the volume plugin that relates to how/how much the volume changes in any way. The plugin doesn't even decide when it gets called, and can only refresh the OSD when gbpvr decides to call it (normally once a second).