mux help

[agidius]

I had been using .ts for quite a while with little problems, but the upgrade to 1.2.9 broke that.

dvr-ms is nothing but a horrible choppy mess.

cyberlink plays VERY nice, but the sound gets farther from the video as the show goes on.
at the end of a 2 hour show, the sound is 6 seconds off.

is there another mux I should try??

has someone with the cyberlink sound problem worked through it??

[CFC]

I had been using .ts for quite a while with little problems, but the upgrade to 1.2.9 broke that.

dvr-ms is nothing but a horrible choppy mess.

cyberlink plays VERY nice, but the sound gets farther from the video as the show goes on.
at the end of a 2 hour show, the sound is 6 seconds off.

is there another mux I should try??

has someone with the cyberlink sound problem worked through it??

You can try the ATI muxer. It's in the catalog in the "Community Annoucements" forum.
I haven't had any sound sync problems with the Cyberlink muxer, but then again, I don't have trouble with the dvr-ms option either.

Good luck
CFC

[agidius]

I have downloaded the ATI one before, but cannot get it to show up in the list in config.
but it does show up in the mux checker

[sub]

I had been using .ts for quite a while with little problems, but the upgrade to 1.2.9 broke that.

Have you tried 1.2.13? I would recommend it. In my testing it has performed much better for transport stream recording.

[agidius]

I downloaded it last night,but havnt loaded it yet.

will give it a try tonight.