ZTranscode session not killed from MVP

[mjpsr11]

I finally have ZProcess running (and with all the right aspect ratios ) on my MVP, but GPPVR doesn't seem to kill a (ZTranscode) process on my OS when I select either stop or exit/back on my remote. The mencoder process will also continue to run until the file is completly transcoded.

Also, after starting a process (selecting a video file) then selecting a new file (after pressing stop or exit/back from the first), the first file starts over but a new session of ZTranscode initiates giving me two process IDs in my task manager. This propogates for each new process or selection of a new file and none of the initiated ZTranscode processes ever die.

The result is that I can't view a different video file after the first one and eventually, my CPU runs to 100% capacity. I finally have to manually kill the processes in task manager.

It looks like GPPVR should be killing ZTranscode (and Mencoder) once MVP gives it the stop signal. Anyone else having this strange issue? Perhaps my installation of ZProcess or config.xml is amiss? Any way for me to run diagnostic on my installation?

[mjpsr11]

Did a little more investigation and found that the problem persists when mencoder is still transcoding a file.

If the file transcoding is completed, mencoder dies, but ZTranscode continues only one process (even after selecting stop from MVP). This allows me to view new files, but I have to wait until any file being transcoded is completed and at least one process for ZTranscode seems to persist indefinitely.