Diseq Switch commands

[kylebrophy]

Hi There,

I now have a 4 way diseq switch with D1/C1/D2 on it.

The issue I have is that when i try to view a channel on D2 (port 3) it just sits there with blank screen (for as long as im prepared to wait) - however if I then enter another channel number on D2, it then springs into life and its fine from then on. This does not happen for any channels on D1 (port1) or C1 (port2).

I remember in the GB-PVR days i had to change a setting in config.xml - that was something to the effect of submit tuning command twice for recording. Im pretty sure if that command was still around in NPVR that might solve my issue.

I guess first question - is that command still valid for NPVR? and secondly, if it is - what is the exact syntax.

Thanks in advance.

[kylebrophy]

sorry guys - i think ive found reference to sumthing similar in <TuneTwiceOnDigitalChannels>true</TuneTwiceOnDigitalChannels>
http://forums.nextpvr.com/showthread.php...post421460

i have a hauppauge card so not sure if this will solve it - but will give it a crack.