HDHomeRun - ATSC - no channels

[ecp]

I'm probably missing something simple, but I'm not getting any channels when I do a scan.

1. I installed my HDHomeRun (non-prime) on my network and attached my antenna
2. I ran its scan and it found 17 channels
3. In the homerun gui, I indicated I was using "nextpvr"
4. In NextPVR Settings->Devices, I see 6 entries.
5. In 'Device setup', I ran the scan on the first of the "ATSC" entries and I get the attached log. It seems to indicate that there are some channels found (or at least I see 8 that are 'locked' and 'present').
6. I get "Scan complete" and no channels are captured.

I have NextPVR 2.5.9. I installed it before I had the HomeRun if that makes any difference.

I shut down my antivirus and my firewall without it seeming to make any difference.

Anyone have an idea what the problem might be?

Thanks,
Ernest

[whurlston]

Signal strength looks a little low on those channels (11, 17, 27, etc). Are you able to view them in the HDHomeRun Config (GUI)?

Also add the following exceptions to your firewall: NextPVR.exe, NRecord.exe and NDigitalHost.exe

[ecp]

Ah. So I just got a black screen when trying to view channels in the HDHomeRun gui. It turns out that I was missing codecs (sorry, I'm completely new at this), so I installed VLC. Now, I can view channels in the HDHomeRun gui. Also, a rescan from within npvr finds the channels. So I guess the missing codecs was causing npvr to not succeed properly. I'm not sure why it didn't log any errors though.

In any case, thanks for the hint!