Digital channel setup

[StevHodge]

I must be doing something very basically wrong. Been upgrading for years, since early GPVR iin the early noughties. Never had a problem before. But on going to 3_5_7 I keep getting the message 'digital chgannels not setup' I did a clean re-install but still got the same message. Attached are all the logs since the re-install. Please tell me what has gone wrong. The system seems to fiind all the channels perfectly OK, but still I get this message, and nothing on the TV guide

Steve Hodge

[sub]

Can you post a screenshot of the message you're seeing?

[StevHodge]

Thanks, sub

Attached are two screenshots. {sorry about the extraneous junk on the pix, had to use a remote machine and teamviewer to get the shots}

The whole process seems a bit odd to my amateur eyes. When NPVR starts I get the sceen I titled StartScreen, if I then click on TV guide I get the Message.jpg screen, but for just a few seconds, then it disappears, and goes back to StartScreen

Steve

[sub]

If you click 'group' at the top of the TV Guide, do your channels show up?

[StevHodge]

If you click 'group' at the top of the TV Guide, do your channels show up?

Thanks, sub, that fixed it. Clicked group, got a drop down menu, found the channels under Digital DVB-T. Seems to be a one time thing. The channels come up straight away now, even after a restart

I suppose it was all written in the instructions somewhere, but I didn't see it - sorry you were bothered

Sent the project another £50 just now It is a great system especially when used with kodi for distribution round the house

Steve

[sub]

I suppose it was all written in the instructions somewhere, but I didn't see it - sorry you were bothered

We only just discovered this could happen a couple of days ago, where the user could end up in a channel group with no channels (after they had been using a channel group, but subsequently deleted the channels and done a rescan).

I've added some logic to deal with this in the next release. When you first go into the group, it'll say something like 'This channel group has no channels, switching to All Channels'.

Sent the project another £50 just now It is a great system especially when used with kodi for distribution round the house

Thanks!