EPG Update - NextPVR has stopped working

[raymondjpg]

I am new to NextPVR and this question may have been addressed before, but I could not find an answer on searching the forum.

After initial setup of DVB-T devices and scan, I run EPG Update and it appears to run through all frequencies successfully but ends with an error message something like "NextPVR has stopped working please close". I close as requested, but NextPVR stays in the system tray, can be opened again, and the EPG appears to be fully populated for all services.

This may not be a significant problem but I would prefer to see the program run its EPG update routine without errors. Is there some solution?

I have set up and completely uninstalled NextPVR two or three times, but the error persists.

(Windows 7 Professional x64; Hauppauge WinTV-dual HD)

[sub]

Reprouce the problem then zip and attach the logs and I'll take a look.

[raymondjpg]

Reprouce the problem then zip and attach the logs and I'll take a look.

Attached zip as requested.

NPVR log shows an error "UnhandledExceptionHandler caught : Object reference not set to an instance of an object." on scanning the last channel. This last channel is on the same service as the penultimate channel.

Thanks for looking at this.

[sub]

Give this patch a go:

http://forums.nextpvr.com/showthread.php...post505682

[raymondjpg]

Give this patch a go:

http://forums.nextpvr.com/showthread.php...post505682

Thanks for the patch. I replaced NShared.dll in the NextPVR Program Files (x86) install directory and the EPG update scan completed without error.

There were other instances of NShared.dll scattered around the PC but I did not replace those with the patch version. Should I need to replace any of those could you please advise?

Regards

[sub]

The only other one should be in c:\users\public\npvr\web\bin, and it gets copied there from "C:\Program Files (x86)\NPVR" when you restart the recording service.

[raymondjpg]

I will do that. Thanks for all your help. So fast!

Edit: Maybe I misinterpreted your response The modified dll appears to have copied itself to the c:\users\public\npvr\web\bin directory.

Regards