HDHomeRun Extend Subchannels

[rlknpvr]

When using HDHomeRun, all OTA channels viewable.

When using NPVR, OTA subchannels (eg. x.2, x.3, x.4) not always viewable.

----------------------------------------

Windows 10 Professional v1607
HDHomeRun Extend v20161119
NPVR v3.9.2(161119), LAV decoder

[mvallevand]

In the HDHR configuration utility do not chose NextPVR for BDA, use Default or Mediaportal.

Martin

[rlknpvr]

BDA already set to Default.

[ccihon]

I have done some testing and found, especially with my ATSC Dual unit, the best BDA settings are either MediPortal or JRiver, not default. Older versions of SD firmware had a choice "Other ATSC/QAM" that worked well, but default in the new firmware is not its equivalent. I do find the stream and ts files are larger at the desired settings, however.

[rlknpvr]

Will test both MediaPortal and JRiver BDA Compatibility Modes in HDHomeRun setup.

[scJohn]

Do those missing sub channels show up in the NExtPVR Settings|Channels screen?

[rlknpvr]

All subchannels are always listed in NPVR Settings > Channels, even those not viewable in NPVR.

After testing, solution appears to be resolved by selecting either MediaPortal or J River Media Center BDA Compatibility Mode and rescanning Channel Scan in HDHomeRun Setup, then deleting and rescanning channels in NPVR Settings.

Thanks for the recommendations.