Channels Not Working

[CountryBoy]

I have tried to get Nextpvr setup the last few days. Each time it seems to work for a few hours, but then stops. Trying a channel it says "starting devices, please wait"  for a bit then says "streaming failed (transcoder exited)"

[mvallevand]

First, for now make sure all power management is disabled on linux, my experience has not been good if devices go into low power mode.

There does seem to potential issues after this line

02:46:52:111 [DEBUG] Stopping device...

I think you are trying to get EPG but that seems to be failing around this and all the follow up recording I'm a bit lost on the status of OTA ATSC EPG on Linux right now, but Schedules Direct is recommended anyway

Martin

[CountryBoy]

I disabled the guide for now and the channels are working.