When Kodi is running, I literally cannot power off my Crenova brand projector.
Whether I press the power button on the device, or on the IR remote doesn't matter. About 5 seconds later, the fan spins back up and the power comes back on.
At first I suspected that HDMI activity was causing it to turn back on. So I installed the "Turn Off" screensaver extension and configured it for Raspberry Pi so that the HDMI signal gets disabled at screensaver time. This problem still occurs even with no active HDMI signal. That is [b]super[/b] confusing!
If I exit from Kodi back to desktop, I can then power my projector off again.
All I want to do is keep Kodi running and some events like mouse move or remote control turns my screen back on again.
Been trying to debug this for hours this evening without success. It's cold here in western NY but I'm sitting here sweating my ass off from the lamp haha.
Oh, and I have a last-ditch plan here which is an actual HVAC to 3v3 relay module that I happen to have handy, and could control by the RPi. Except that's really lame and makes an annoying click noise. There must be some software fix here.
Any help is really really appreciated. I'm so close!appvalley tutuapp tweakbox
Whether I press the power button on the device, or on the IR remote doesn't matter. About 5 seconds later, the fan spins back up and the power comes back on.
At first I suspected that HDMI activity was causing it to turn back on. So I installed the "Turn Off" screensaver extension and configured it for Raspberry Pi so that the HDMI signal gets disabled at screensaver time. This problem still occurs even with no active HDMI signal. That is [b]super[/b] confusing!
If I exit from Kodi back to desktop, I can then power my projector off again.
All I want to do is keep Kodi running and some events like mouse move or remote control turns my screen back on again.
Been trying to debug this for hours this evening without success. It's cold here in western NY but I'm sitting here sweating my ass off from the lamp haha.
Oh, and I have a last-ditch plan here which is an actual HVAC to 3v3 relay module that I happen to have handy, and could control by the RPi. Except that's really lame and makes an annoying click noise. There must be some software fix here.
Any help is really really appreciated. I'm so close!appvalley tutuapp tweakbox
