2005-08-18, 01:20 AM
For a while I've been looking for solutions to the random audio loss I was getting on certain stations using my Hauppauge PVR-150, and finally found that I could solve the problem when I fine-tuned the stations in WinTV.
I searched these forums to learn that I could use Tuning Assistant or FreqCopy to get this working in GB-PVR now. FreqCopy seemed like the easiest method so I ran that, but now it seems everything's off in GB-PVR. For most of the lower channels, it shows channel 2's signal (no sound) and doesn't change whenever I press channel up/down (though the OSD guide shows the changes in guide info) and most of the higher channels do similar things with other stations.
I attempted to undo this by deleting the "TV AutoTune/TS0-0" registry entry that FreqCopy copied to, but to no avail.
So, I guess I have two questions:
1) What can I do to clear whatever channel frequencies GB-PVR is now using and start anew?
2) Is there anything you can think of off hand that I did wrong when using FreqCopy?
Of course, any help is greatly appreciated!
I searched these forums to learn that I could use Tuning Assistant or FreqCopy to get this working in GB-PVR now. FreqCopy seemed like the easiest method so I ran that, but now it seems everything's off in GB-PVR. For most of the lower channels, it shows channel 2's signal (no sound) and doesn't change whenever I press channel up/down (though the OSD guide shows the changes in guide info) and most of the higher channels do similar things with other stations.
I attempted to undo this by deleting the "TV AutoTune/TS0-0" registry entry that FreqCopy copied to, but to no avail.
So, I guess I have two questions:
1) What can I do to clear whatever channel frequencies GB-PVR is now using and start anew?
2) Is there anything you can think of off hand that I did wrong when using FreqCopy?
Of course, any help is greatly appreciated!
