Install Problems Twinhan

[RajDarge]

I installed GB-pvr after installing twinhan BDA drivers. Everything worked fine. Off course the TWINHAN software then didn't work with the new BDA drivers so I uninstalled the drivers and re-installed the Twinhan ordinary drivers.

Thus twin han worked and Gb-pvr didn't. Then I decided I liked gb-pvr and went back to the bda drivers. Now nothing works. There is no MUX thingy and its all quite painful.

I get a message:
"Please point me to the config folder" and the app just sits there for ever with a file-lister asking me to enter something. Of course its half frozen so I can only move the window around, but I can't actually select the config folder (not that I know where it is anyway). This happens when I select my capture device and try to copy epg settings or something like that. I have updated My EPG.

I am in NSW Aus. I am using a good aerial. I have selected TWINHAN BDA driver and EPG is the channel thingy.
It worked the first time but Not now.
I have de-installed it, and re-installed it 4 times.
I have edited the registry looking for gb-pvr gbpvr and pvr. and tried to remove all reference to it.

I have a feeling its a mjet odbc problem but am not smart enough to know what the acronyms stand for.

Please help before I kill myself.

Raj
:mad:

[sub]

I get a message:
"Please point me to the config folder" and the app just sits there for ever with a file-lister asking me to enter something. Of course its half frozen so I can only move the window around, but I can't actually select the config folder (not that I know where it is anyway). This happens when I select my capture device and try to copy epg settings or something like that. I have updated My EPG.

This 'point to config folder' window is generated by the ShowShifter mux filter. Try using a diffent mux, or uninstalling ShowShifter if it's an expired evaluation.

[RajDarge]

ta muchly for the quick advice.

where too much software is just... too much software.

Raj