(2)PVR 150 and 2 STB

[cybrob]

I have 2 150 and 2 stb's. How do I configure the cards? As capture source 1 and capture source 2? Then how do I set the channel changer? Use the one for exe and then to haupblast.exe? Then do I have to have a blaster on each STB or just one? If just one how does it change the channel on the other STB? THanks in advance for your assistance.
CybRob

[sub]

Unfortunately I think you'll only be able to control the one STB with the Hauppauge IR Blaster, so you'd probably need to add another type of IR Blaster to your machine to control the other one. USB-UIRT or MCE2005 blaster etc.

[cybrob]

so I cannot use two IR blaster, the ones that came with each PVR150?

[sub]

As far as I can tell the Hauppauge IR Blaster software only allows one to be used.

[cybrob]

so if I have set two capture source I cannot use both IR Blaster that came with both cards?

[sub]

I suspect when you try it'll just end up using the one functional IR Blaster, using the code set you've configured in the Hauppauge BlastCfg app.