Channel does not change to record

[JimmyA]

Hi,

I am running both GBPVR and nPVR. When I set a recording in nPVR the channel does not change at recording time. My device is set up as Fixed Channel 3 and it appears to always tune to channel 3 when a recording starts, no matter what channel the recording is set to.

I don't recall having to do anything special for GBPVR. What am I missing?

Thanks

[sub]

My device is set up as Fixed Channel 3 and it appears to always tune to channel 3 when a recording starts, no matter what channel the recording is set to.

That sounds correct to me.

Is your question about an IR Blaster?

[JimmyA]

In GBPVR my stb changes to the channel I have set to record. This is not happening in nPVR.

[sub]

Which IR blaster are you using to control your STB?

[JimmyA]

I am using a firewire connection and the Timm Moore's channel.exe.

[JimmyA]

Forgive me. I had miskeyed the parameters. Used () instead of {}.

Sorry to waste your time.

[martint123]

Forgive me. I had miskeyed the parameters. Used () instead of {}.

Sorry to waste your time.

Don't worry, not a waste if you got it sorted and maybe someone else sees this post. I find some fonts are quite poor at differentiating between the two sets of braces and it is all to easy to get them wrong..