2011-04-20, 11:33 AM
We had Analogue switch off last night so most of the Mux have changed frequency overnight. I edited the transmitter ini file with the new frequencies, deleted all channels, did a rescan, updated EPG and all seems to be working except NO âPending Recordingsâ. I check the logs and there is an error every time it tries to create a pending recording after the EPG update. Going back earlier in the logs there are numerous comments that âFrequency has changed so stopping recording from previous frequencyâ.
I setup a new test recurring recording the same as a failed one and did a recordings export. The only difference is that the âChannelOIDâ has changed. I imported two recurring recordings where I had changed the âChannelOIDâ to the new one and these now appeared as pending recordings. I edited the recurringâbackup.xml and updated the âChannelOIDâ of each channel, deleted all current recurring recording, imported the file and there were all the pending recordings.
Is there an easier way of doing this?
I setup a new test recurring recording the same as a failed one and did a recordings export. The only difference is that the âChannelOIDâ has changed. I imported two recurring recordings where I had changed the âChannelOIDâ to the new one and these now appeared as pending recordings. I edited the recurringâbackup.xml and updated the âChannelOIDâ of each channel, deleted all current recurring recording, imported the file and there were all the pending recordings.
Is there an easier way of doing this?