2012-02-29, 05:21 PM
Is there a way to record only a specific audio stream in ATSC broadcasts? I occasionally want to keep some ATSC recordings so I trim the pre and post-padding and commercials if any. These broadcasts have two AC3 audio streams, there's a high bit-rate (sometimes 5.1) and a low bit-rate stream. Unless I remove one of the streams the trimmed recording has the two streams merged together in a mess.
I'd prefer to eliminated the step of cutting a stream before trimming. Can NPVR just record a single audio stream? Thanks.
Details:
Win7
NPVR 2.3.6
HVR-1600
I'd prefer to eliminated the step of cutting a stream before trimming. Can NPVR just record a single audio stream? Thanks.
Details:
Win7
NPVR 2.3.6
HVR-1600