dvb-s scan incomplete

[cal007]

Hello Dear members,
I just installed recently the version 2.59 of nextpvr. I am using a DVB-S/ S2 sat card for TV and radio.
After installing everything the TV card was detected as expected (BDA). I am on Astra 19,2 so I started channel scan.

I observe that the scan does not result in finding all channels. I updated the sat ini file in order to provide all frequencies, but not a big change.
every time I scan, it finds a few more channels, but far from the complete list. It seems as it does not detect all the channels per frequency.

Does anybody have the same problem or am I doing something wrong?

Also, I do not find any BDA.ini, as stated in some other threads here....but which seems to be for the former GB-PVR valid only. I suppose it is not related to that ini anyway, as the TV card is working in principle.

Thank you for providing a hint.

Best regards,
cal

[sub]

When looking at these types of problems before, I've found it best to focus on a single frequency where you are missing channels. If you get no channels for that frequency, then we can check if the logs indicate the device managed to lock onto a signal. If you got some channels for that frequency, then I can look at the npvr.log to see if there is if there is a reason that specific channels are not being included. If need be we can also get you to supply a transport stream for that frequency, so I can try running it here in the debugger.

You'll need to pick which of those frequencies you want to focus on, since you're more familiar with your German broadcasts than me.

The BDA.ini is not needed for NextPVR, and wont be a factor here.