EPG Update not updating channels with DVB/ATSC EPG

[SailTV]

After installing 2.6.2 I no longer get updates for channels with DVB/ATSC EPG. Only the channels using XMLTV are updated. The status window that opens shows "Checking for any XMLTV listings" then "Running PostUpdateEPG.bat" then closes. In 2.5.9 the status window would show "Checking for any XMLTV listings" then "Checking for DVB/ATSC EPG listings" then close.

John

[Reddwarf]

After installing 2.6.2 I no longer get updates for channels with DVB/ATSC EPG. Only the channels using XMLTV are updated. The status window that opens shows "Checking for any XMLTV listings" then "Running PostUpdateEPG.bat" then closes. In 2.5.9 the status window would show "Checking for any XMLTV listings" then "Checking for DVB/ATSC EPG listings" then close.

John

You must post your logs after updating the epg. See the sticky thread first in this forum.

[SailTV]

Sorry. Here are the logs.

[johnsonx42]

were you running the 2.5.9 unpatched, or did you have at least the R2 update installed? I ask because there was a change to the messages during the update process added with the R2 update; I wonder if that update inadvertently broke something.

[johnsonx42]

your logs say your tuner was in use when you tried to update the EPG.

but I don't see anything to indicate the tuner actually was in use. there was an update at some point recently to disable the OTA epg update if the tuner was in use, since before the EPG update would just stomp on any recording in progress. perhaps the logic is broken somewhere now and thinks the tuner is in use when it's not.

[SailTV]

Clicking "Empty EPG" before clicking "Update EPG" got it working. It runs the DVB/ATSC EPG scan now.