Another - No tuner available

[Jaggy]

I have three DVB-S tuners in this PC, 2xHVR-3000's & 1x HVR-4000, I have set them up with one transponder/mux per card (to avoid loosing padding on recordings) (apart for C4 which is enabled on all three cards).... I can watch live TV off all three transponders, but when I go to setup a recording from TV3 & another recording from Prime (or vies-versa) I get the old no tuner available do you want to cancel message.... which is a tad weird as TV3 is on one of the hvr-3000's & Prime is on the hvr-4000??? logs attached

[Jaggy]

Here are some more logs after I actually did a recording off TV3 (& then tried to record Prime as well & got the no tuner message) then cancelled the TV3 recording & did a Prime recording..... it did in fact use a different tuner for each recording so shouldn't have shown a conflict??

[stustunz]

http://forums.nextpvr.com/showthread.php...s+stustunz

Here is the fix i had to use may be the same, may not.

[Jaggy]

Thank you for that, yep that was the issue..... sodding old age & my memory let me down again.... I think it was a message from me (for a friend not myself) that prompted the change in devicerules.xml that causes the problem as all I did was rem out the new bit sub added & away it went.

Code:

        <!-- Hauppauge 88x family -->
        <Filter name="Hauppauge WinTV 88x DVB-S/S2 Tuner/Demod" resource="Hauppauge 88x" />
    <!--    <Filter name="Hauppauge WinTV 88x DVB-S Tuner/Demod" resource="Hauppauge 88x" /> -->
        <Filter name="Hauppauge WinTV 88x DVB-T Tuner/Demod" resource="Hauppauge 88x" />
        <Filter name="Hauppauge WinTV 88x Video Capture" resource="Hauppauge 88x" />

[sub]

Yeah, it's an unfortunate scenario that happens when you mix HVR-3000/HVR-4000 in the same machine. Thankfully, it's not common, and there is a workaround.