2015-05-25, 12:58 PM
Has something changed in 3.4.8 that would prevent tuning satellite channels? I noticed that it stopped finding any channels after only very few. The behaviour was the same on two separate machines utilising different dvb-s cards, both are internal pci types that have always worked before, different makes, as were the two PCs. Tuning was to the Astra 19.2 array.
Steps I've taken to verify problem:-
1) Clean install of 3.4.8 after backing up and getting rid of everything including the \public\NPVR data folder. Problem reproduces as described above even with no channels in a pristine database. Log files captured.
2) Clean install of 3.3.8 in same circumstances. Completely normal scanning and channel detection behaviour. Log files captured.
3) There is no problem with dvb-t tuning - this works as expected in 3.4.8 and 3.3.8
Log files captured from (1) and (2) above are in attached zip file. In both cases (1) and (2) I terminated the scans once they had been running long enough to clearly demonstrate the issue.
Steps I've taken to verify problem:-
1) Clean install of 3.4.8 after backing up and getting rid of everything including the \public\NPVR data folder. Problem reproduces as described above even with no channels in a pristine database. Log files captured.
2) Clean install of 3.3.8 in same circumstances. Completely normal scanning and channel detection behaviour. Log files captured.
3) There is no problem with dvb-t tuning - this works as expected in 3.4.8 and 3.3.8
Log files captured from (1) and (2) above are in attached zip file. In both cases (1) and (2) I terminated the scans once they had been running long enough to clearly demonstrate the issue.