Tuner Status in logs not working

[jcjefferies]

For quite a few months the tuner status in the logs on my NextPVR server has always read all zeros for all tuners I have tried even though the recordings made are good and play normally. The same happens on a couple of test servers I tried.

2015-10-14 11:30:17.522 [DEBUG][5] whoosh whoosh
2015-10-14 11:30:17.525 [DEBUG][5] locked=0, present=0, strength=0, quality=0 (took 0ms to check)
2015-10-14 11:30:17.528 [DEBUG][5] DigitalRecorderDVBT::Tune@8
2015-10-14 11:30:17.622 [DEBUG][5] File size is 0

I have just bought a new DVB-T2 and the status info would have been helpful while setting it up.

Chris

[sub]

Some drivers just don't report signal information, so these are always zero.

Some drivers cant report the signal information until slightly later in the process. The next release moves that signal reporting to later, which should help in those scenarios.

[jcjefferies]

Thanks Sub. I was wondering if copying some corrupt data in the config file or database when I recently did a clean install of Windows may have caused the problem.

I am sure that it did work so installed NextPVR 3.2.9 on a clean install of Windows and the status info correctly displays for the three tuners I have. However when I upgrade to ver 3.5.7 the tuner status is all zero again.

Chris