Indication if recording has been seen to the end.

[psycik]

I may look at "helping" gbpvr update this value - unless sub sees this and decides that there shouldn't be 2 things updating the same table.

I know I see a user hitting the stop command, but that seems to be getting updated. I'm not sure if I'm told that the video is stopping if the user doesn't initiate it.

[martint123]

so exiting the video near the end made it correctly report the video as a high percentage complete?

Sorry, I was in a bit of a dash. I've just checked one that the OH watched to the end.

If I 'resume' after it has run to the end, it restarts about 7 seconds before it ends.

If I stop it just before the end, it resumes in roughly the same place.

The program is reported to run 0235 to 0305 and in the database the resume position is at 1790. Your plugin reports it as 87,6% viewed.

Martin

[psycik]

So I've just recalculated that and I work out that should be 99.4% complete (1790 / 1800 = .994 - 1800 being 30 minutes in seconds). Ok maybe my calculations have been out all this time. I'll look at that.