4.0.4 freezes to one channel

[Krepps]

I have done clean install again. One thought was maybe drivers to Hauppauge TV card so up graded them but did not help. So would like to re explain my problem again.
Every morning the status says it is still recording last night program. If i restart the service it will work. But it hangs to last recording made.
Attached log files
[ATTACHMENT NOT FOUND]

[mvallevand]

I can speculate based on that screen shot that it isn't the last shown in the tray it was the 6 o'clock news. Looking at the looks for last night there is no indication that the recording

2017-08-10 17:59:02.605 [DEBUG][9] Started recording (15383:1:O:\NEXTPVR -GIL-07\wusa 9 News at 6pm\wusa 9 News at 6pm_20170810_18001830.ts)

finished or went through the post processing logic.

There is other indication of the problem on the open handle #1 in ndigitalhost-21.log.1

2017-08-10 18:30:00.255 [DEBUG][42] Frequency has changed, so stopping recording from previous frequency. (Handle 1)
2017-08-11 02:11:50.207 [DEBUG][68] Frequency has changed, so stopping recording from previous frequency. (Handle 1)


Martin

[Krepps]

UPDATE ON PROBLEMS
After thinking it may be hardware driver problem even though one computer is working with same drivers i reinstalled Nextpvr after updating drivers and also reinstalled channels and for some reason one computer appears to now work. Really did nothing different
But one computer since updating driver and other problem I got BSOD and after much work I had to do a clean install of windows 10. After this I installed Nextpvr and it is still doing the same thing.
To get it to work I have to go to to task manager and stop nextpvr 32 bit, close program and reinstall 4.0.4 and it works till tomorrow. When it again hangs after last recording.

Attaching logs with problem and logs after reinstall,if that might help. Also screed shot of statue window

Thanks in advance for your help.

[mvallevand]

Same problem I explained before on the "bad" server NextPVR is not stopping the first 6pm recording properly on back to back recordings (no post processing log messages etc). This time Handle 16 gets stuck. I believe it is similar to BrettB's problem https://forums.nextpvr.com/showthread.ph...post513074 and sub needs to look into it.

You don't have any recordings on the other box, it is just used for live tv so this is not a valid comparison of the problem

Martin

[Krepps]

After many times retrying 4.0.4 does not work even on a clean install of windows 10. Tried to go back to ver 2.9.2 and had problems with setting schedule direct and more. Thinking the last time 2.9.2 worked i had not done a clean install but install over 3.7.7. So install ver 3.7.7 and it work. Also tried to install ver 2.9.2 over 3.7.7 and still had problems. So did a clean install of 3.7.7 and it works. Long live 3.7.7