No video/audio

[stustunz]

sorry i meant for setting Npvr up
not all the time

[Hal2010]

sorry i meant for setting Npvr up
not all the time

OK. I have recorded a program with NPVR and played it back using PowerDVD9. I get both video and audio. PowerDVD tells me the audio is AAC 2.0. Then I try to play it back with NPVR and get video but no audio. The other AAC audio decoders get the same result.

Prior to launching the NPVR playback I set the 'AAC decoder' to my ArcSoft Audio Decoder. After the playback the setting has somehow been set to 'Disabled'. So now I try 'setting' it back to ArcSoft , OK(to exit settings) and immediately go back into 'settings\decoders' to check the setting of the AAC Decoder. It has been reset to 'disabled'. The other AAC audio decoders get the same result.

[stustunz]

you need to install mongram audio decoder google monogram
link for you http://blog.monogram.sk/janos/2008/04/20...oder-0950/

power dvd wont let you use the audio decoder

power dvd is fine for video as you know as you have video playing back fine

[Hal2010]

you need to install mongram audio decoder google monogram
link for you http://blog.monogram.sk/janos/2008/04/20...oder-0950/

power dvd wont let you use the audio decoder

power dvd is fine for video as you know as you have video playing back fine

monogram codec is 'not compatible' with Vista 64 bit and wont install..

[stustunz]

did you register the file
its not a install file

[Reddwarf]

And BTW, most codecs called AAC is actually HE-AAC, so set the appropiate decoder there also (in Settings->Decoders). For Monogram you need to run .\windows\system32\regsvr <filename>.ax

Edit: If it is an x64 system you probably should use .\windows\SYSWOW64\regsvr32.exe <filename of decoder>.ax

[Hal2010]

did you register the file
its not a install file

Sorry got called away. Yes I did - extracted mmaacd.ax and copied it to C:\WINDOWS\SYSTEM32 then

run regsvr32 mmaacd.ax

and got this message
"mmaacd.ax" may not compatible [sic] with the version of Windows that you're running. Check if the module is compatible with x86 (32-bit) or x64 (64-bit) version of regsvr32.exe.

Want me to try again. Maybe I had finger problem

[Reddwarf]

Hal2010: Are you running x86 or x64 operatingsystem?

[Hal2010]

Hal2010: Are you running x86 or x64 operatingsystem?

Vista Ultimate 64-bit

[stustunz]

i think you have to put it in the right folder go back a few posts #26 then try to regsister it again

If it is an x64 system you probably should use .\windows\SYSWOW64\regsvr32.exe <filename of decoder>.ax

im pretty sure it works on 64bit systems
just has to be in the right place