GetFilterProperty filling up log

[xinl]

[ATTACHMENT NOT FOUND]Hallo,
I have added a second card to my system but have been unable to get it to work sucessfully. When I have it enabled and configured in the config program and then attempt to record something, I get the following error in the GBPVRRecordingService.exe-native.log
This very quickly fills up the log file and my harddisk.

17:25:33.421 VERBOSE GetFilterProperty - IKsPropertySet- >QuerySupported property failed

Exisiting tuner is PVR350, new is PVR150
After search the forums, I have tried the following, restarting the recording service each time.
1) Adding INIT_MODE=ECP or INIT_MODE=DEFAULT in the device.ini
2) Changing INIT_MSP=1 to INIT_MSP=0
3) Swapping the device nummers of the cards in the config program.

Any more ideas? Hear are my current logs and device.ini. I have removed the new card from the config capture source so prevent problems overnight.

[sub]

Your PVR350 is probably moved to device #2, and the new PVR150 is device#1. If the card type does not match the device type, you'll get these sorts of errors.

Try swapping the numbers in your capture source settings.

[xinl]

Thanks for the quick reply, for myself I needed to get to bed!
I have tried swapping the numbers (Board Number = Capture Device #) to no avail. I presume the order of the Capture sources is not relevant?

If I set two shows to quick rec, the first one with record and the second will stay on pending. The log starts filling up with the GetFilterProperty line even with just the one recording active, and it fills up very fast. 100Mb in under a minute.

Just did a test. Even with only one capture source created, it does this. I have to disable the new card before I can use GB-PVR properly.

[xinl]

Well I have to eat my words, I tried switching the device numbers again and recreating the capture source and now the log file has stopped growing with the GetFilterProperty.

However I am getting another problem, when recording two shows at once. The PVR150 is device 1 and records the first show fine. But the second show on de PVR350 shows a blank red screen and the audio seems to be from the radio tuner.

I have checked my cabling and I am getting a TV signal on the correct cable. Any ideas from anyone? I don't have unlimited time to fiddle with the system, but I wonder if it is worthwhile swapping the hardware cards around and making the PVR350 the first device.