No OSD

[scott012]

Hi,

I can't seem to get the on screen display to work. I am watching on my desktop monitor. Any ideas?

[sub]

The usual cause for this, is when the user is trying to use the Cyberlink decoder with VMR, without adding the Cyberlink EnableVMR9=1 registry setting. By default the Cyberlink decoder only works with Overlay.

[scott012]

I am using the Cyberlink decoder... Where would I edit the registry value?

[Carlito]

I beleive the setting is under
HKLM/Software/Cyberlink/Common/CLVSD/
add EnableVMR=1\

if that does not work then try adding it here as well
HKCU/Software/Cyberlink/Common/CLVSD

[scott012]

That key already existed and the value was 1. Will I get the OSD in Overlay mode?

[Carlito]

The osd should come up in overlay but you will lose the transparency