HELP: INI for ATI ALL-IN-WONDER 9200

[neuber]

I have an ATI ALL-IN-WONDER 9200.

I'm trying to setup GB-PVR to work with this capture card.
I thought I was tech savy, but I can't figure it out.

:confused: Any suggestions?:confused:


[Your Digital TV card name ]
TUNING_TYPE=DVB-T
FILTER_TUNER=Your TV cards Tuner Filter name
FILTER_CAPTURE=Your TV cards Transport Stream Capture filter name
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

If you only have a filter name is listed in both the Receiver section in GraphEdit, use the following bda.ini entry instead

[Your Digital TV card name ]
TUNING_TYPE=DVB-T
RECEIVER_ONLY_MODE=1
FILTER_RECEIVER=Your TV card’s filter name
PIN_RECEIVER_IN=Antenna In Pin
PIN_RECEIVER_OUT=MPEG2 Transport

[sub]

I'm sorry but the All-In-Wonder cards do not work with GB-PVR. They lack the required hardware MPEG2 encoder.