2007-03-18, 04:13 PM
(This post was last modified: 2007-03-18, 04:20 PM by nicelittle.)
Issue: I have to run the OnAir TV program briefly every time I restart the
computer or resume from standby. Otherwise, GBPVR fail to tune the OnAir
GT. I seem to remember the tuning mode of OnAirGT being set to over the
air by default and GBPVR cannot use it until the device is set to QAM by
te included TV program.
Can this problem be fixed on the GBPVR side? Thanks.
Forgot to mention I'm using 99.12 and the latest (3/17/07) OnAir driver.
The problem existed with the previous OnAir drivers.
computer or resume from standby. Otherwise, GBPVR fail to tune the OnAir
GT. I seem to remember the tuning mode of OnAirGT being set to over the
air by default and GBPVR cannot use it until the device is set to QAM by
te included TV program.
Can this problem be fixed on the GBPVR side? Thanks.
Forgot to mention I'm using 99.12 and the latest (3/17/07) OnAir driver.
The problem existed with the previous OnAir drivers.