v0.23.13 (maintenance release)

[Ken555]

Media MVP Problems ?

Does this version work with the MVP ?

I did a fresh install windows install on the machine and installed V0.23.13 and when I power up the MVP it sits at the 2 blue/3 white stage for ever.

If I restore V0.22.7 from a backup (the whole DENZ directory) it works fine.

Tried an upgrade to V0.23.13 and it stops at the same stage again.

Any idea ?

[WJC]

Is it correct that GB-PVR will load and boot the MVP directly?

I have not been able to do that but have had to first boot the computer with the Hauppauge Software, unplug the MVP and then replug it after 5 seconds so that it loads the Hauppauge software, turn off the MVP with the remote, turn off the Hauppauge server on the computer, and then start the GB-PVR server on the computer. At that point when I turn on the MVP with the remote GB-PVR then loads just fine.

If I unplug the MVP then I have to go through the same sequence again to get GB-PVR to run. Having not used previous versions of the software I just assumed that was the process.

The previous post seems to indicate that in past versions all these steps were not necessary and that the Hauppauge software was not needed evertime the MVP plug was pulled.

[WJC]

Sorry hit the button twice. Second set of text deleted...

[Ken555]

Yes using V 0.22.7 it was possible just to use the software on it's own. Thats what I'm doing now.

But the newer version doesn't. I've missed a few upgrades do I don't know when this started to happen.