Help..upgraded to 1.15, no mvp WAF low

[largelumox]

Martin / Sub,

After almost a year of trouble free PVR'ing...WAF quite high.....I have a problem

I upgraded to 1.1.5 this afternoon (from 1.0.16), and all is ok on the main machine, client machine also all ok.

I have 1 mvp which has been running an mvpmc dongle from Aug 24...i think.

Long story short, after the upgrade, the mvp is stuck on contacting MediaMVP BootServer. I have tried a couple of different dongles (newer), no luck there and mvp logs are 0kb.

Can ping the mvp no problem, have tried turning off firewall on server

Any ideas?

[sub]

Enable log flushing in the config app, then hit the 'ok' button to apply it, then wait a couple of minutes then zip and attach the logs.

[sub]

Have you tried telnet'ing to the MVP address?

[mvallevand]

Whil its at the main screen the mvp is still running the firmware so you can't telnet yet. However sometimes when I am eager to try a new version I forget to restart the recording service that I turn off todo the install.

Martin

[nia]

Any ideas?

The obvious that I'm sure you've tried, but behaviour sounds like the MVP needs a full power off (PSU connector disconnected) for ½ minute and then a cold boot...

[largelumox]

Sub,

logs attached.

Tried to telnet in connect failed on port 23.

[mvallevand]

Actually 1.1.5 doesn't require that you reload a new mvpmc dongle. Power on should do it.

Martin

[largelumox]

I have tried mvp power off...disconnected power lead, followed by disconnect ethernet cable....reconnect etc. Power back up, no worky. repeat followed by reboot server....no worky...kick cat....feel slightly better, but still no work...

thanks for all the suggestions so far though

[sub]

Sorry, I dont know. There is literally nothing in the logs.

[mvallevand]

I don't see the current recording service logs.

Edit: I see that you aren't starting a mvpserver either

2007-11-11 19:51:33.156 VERBOSE [1] getValue: /settings/MVPServerAutostart : 0

Martin