Setting up 2 PCHs

[agerdin]

Martin,

I have just got my 2nd PCH and planned to set it up for my living room. However, I need to have a separate config for that setup since I do not have any more HDMI on my TV (have to run component instead).

I hope this is possible but I was not sure how to do the startup scriot since I need one setting for analog and one for HDMI. My other first setup uses HDMI.

I will then ofcourse autostart a 2nd server and add a section in config.xml.

Is this setup at all possible?

\\Anders

[philly_phenom]

I have two PCH's set up (one is configured for NTSC & the other for 1080p - although I only have the menus @ 720p for speed).

Just create a second mvpmc share & copy everything from your first share into the second one. Then update the scripts in the new share to match your desired configuration on your new PCH.

Point the new PCH to this new share & go.

Multiple PCH's work fine for me with each pointing to it's own share.

[agerdin]

Cool, did not think about creating 2 shares. Will try.

Thanks philly_phenom

\\agerdin

[mvallevand]

You can do two shares, but I have have one share which contains gbpvr.cgi, gbpvr1.cgi, startmeup and startmeup1 and then I added a line to telnet.html to select.

Martin

[agerdin]

Actually, that sounds like a more straight forward setup. Ill see what Ill do.

Thanks,

\Agerdin

[mvallevand]

I forget the easiest solution. If you use the PCH setup program to store one of the standard tv mode's http://www.networkedmediatank.com/wiki/i...command.3F you don't need to use any command line options.

Martin