More No Sound

[elecdrum]

I seem to have the same problem as the previous poster and cant figure out why so I'll zip you the logs if I may, perhaps you can make sense of them. No sound, always says its scanning and crashes GB-PVR so that I have to use task manager to get out of it.

[Taw]

I had similar problem when first trying dvb-t radio and it turned out to be channel logos causing trouble. You need to ensure that the channel logos are copied to media/channel logos folder.

[bgowland]

I seem to have the same problem as the previous poster and cant figure out why so I'll zip you the logs if I may, perhaps you can make sense of them. No sound, always says its scanning and crashes GB-PVR so that I have to use task manager to get out of it.

The log suggests the same problem that Graham had (towards the end of the original support thread).

Are you running XP with SP3? If so, make sure you have the 3.98 Beta version of the LAME Directshow filter. See the link in the Installation instructions on the wiki.

Cheers,
Brian

[elecdrum]

Windows xp reports it is service pack 2, however, I unregistered the older Lame encoder and registered the beta version but the errors reported in the logs remains. As does the GB-pvr crash.
Logos all appear so I must have them in the right place.

[bgowland]

Windows xp reports it is service pack 2, however, I unregistered the older Lame encoder and registered the beta version but the errors reported in the logs remains. As does the GB-pvr crash.
Logos all appear so I must have them in the right place.

Could you open the 'DVB-T Radio\graphs\Dvbtr.grf' file with GraphEdit and take a screenshot then zip and attach it here please.

CHeers,
Brian

[elecdrum]

Here is the graph

[bgowland]

I'm not sure it will help but could you try installing the MPA decoder from here...

http://www.free-codecs.com/download/MPA_Decoder.htm

If it doesn't them I'm at a bit of a loss.

Cheers,
Brian

[elecdrum]

firstly unregistered the Lame.ax and registered the mpa no sound but no crash.
Re registered Lame and crash reappeared.

[bgowland]

firstly unregistered the Lame.ax and registered the mpa no sound but no crash.
Re registered Lame and crash reappeared.

Sorry - should have said, the lame.ax is still needed.

The MPA Decoder is an audio decoder that should take priority over the Compro Audio Decoder I spotted in the graph screenshot. When you re-registered LAME, did you leave the MPA Decoder as registered? If so, can you check it was being used in the Dvbtr.grf file?

Cheers,
Brian

[elecdrum]

I checked the graph and the new decoder is there.
Any more ideas for me to try ?