No video in Live TV, Only Audio

[fudge03]

I have a Hauppauge HVR 3000 card which I have configured to use an analog input (shows up as both HVR 1300 and HVR 4000 in capture sources when using the "show only devices connected" option). I can use the Tuning Assistant to successfully scan for channels, and the MUX checker finds my Cyberlink decoder. However, when in Live TV, I have audio only on all the channels, no video. I also get the message "no tuners are available to watch the requested channel". I've tried different MPEG decoders (Nero, InterVideo) - all do the same.

So I guess my question is: Is there a "correct way" to set up my HVR 3000 properly instead of it showing up as the 1300 and 4000 (notice there is no 3000 in the list). Or is this another issue - I'm a little stumped?

[fudge03]

Here's the bit of my direct.ini that I'm using...

[Hauppuage HVR-4000]
ARCHITECTURE=88X
INIT_MODE=DEFAULT
INIT_MSP=0
SUPPORTS_FM_RADIO=1
BLACKBIRD=1
CONEXANT=0
FILTER_CROSSBAR=Hauppauge WinTV 88x Crossbar
FILTER_CAPTURE=Hauppauge WinTV 88x Video Capture
FILTER_TV_TUNER=Hauppauge WinTV 88x Tuner
FILTER_TV_AUDIO=Hauppauge WinTV 88x TvAudio
FILTER_CAPTURE_AUDIO=Hauppauge WinTV 88x Audio Capture
FILTER_ENCODER=MainConcept (MCE) MPEG Encoder
PIN_CROSSBAR_VIDEO_TUNER_IN=Video Tuner In
PIN_CROSSBAR_AUDIO_TUNER_IN=Audio Tuner In
PIN_CROSSBAR_VIDEO_DECODER_OUT=Video Decoder Out
PIN_CROSSBAR_AUDIO_DECODER_OUT=Audio Decoder Out
PIN_TVTUNER_ANALOG_VIDEO_OUT=Analog Video
PIN_TVTUNER_ANALOG_AUDIO_OUT=Analog Audio
PIN_TVAUDIO_TV_AUDIO_IN=TVAudio In
PIN_TVAUDIO_TV_AUDIO_OUT=TVAudio Out
PIN_CAPTURE_ANALOG_VIDEO_IN=Analog Video In
PIN_CAPTURE_ANALOG_AUDIO_IN=Analog Audio In
PIN_CAPTURE_PREVIEW_AUDIO_OUT=Video Virtual Out
PIN_CAPTURE_CAPTURE_OUT=Capture
PIN_CAPTURE_I2S_OUT=I2S
PIN_CAPTURE_656_OUT=656
PIN_ENCODER_I2S_IN=Audio Input
PIN_ENCODER_656_IN=Input
;PIN_ENCODER_OUT=MPEG2 PS
PIN_ENCODER_OUT=Output
PIN_WRITER_INPUT_IN=Input

[fudge03]

I've also installed the NativeUtilities patch that sub posted, and have installed SoftMCE from Hauppauge...

[fudge03]

OK. Reregistered codecs using regsvr32.exe, seems there was something wrong there. All OK now.