Help with Win-TV HVR-950q.Please

[jocoman]

I am trying to configure this source.
I can get the analogue going, but no digital.
I update my epg, scan the channels and then map.
When i go to play, it tries to display but it can't .
I get a message that says "no signal detected".
That's BS, I have loads of signal. It also found the channels when it scanned.
Not sure where to look but would appreciate some help.
Currently I have configured as a digital source only on a fresh install in XP SP3.

Thanks in advance.

Jim

[sub]

Reproduce the problem, then zip and attach the logs and I'll a look.

[jocoman]

Which logs are u interested in.
I am a newbie.
Is there "a how" to on log capture.
I'll start seaching for what you need
Thanks
Jim

[jocoman]

OK.
I have reproduced and here are the logs.
Thanks again..I 'preciate it.
Jim

[jocoman]

I reproduced again.
Here are the logs/\.
Thanks
jim

[jocoman]

ops, with the logs

[sub]

Does changing the audio/video decoders helps? There is nothing obvious in the logs, but I did notice its using a decoder I've never seen in abother user's logs (Sonic DVB-PES/PS DS Video Decoder).

[jocoman]

Ok. i have a picture now, but a more sinister problem has crept in.
As i change amongst digital chammels I get a Microsoft error that needs to terminate pvrx2 with this error.

AppName: pvrx2.exe AppVer: 1.0.0.0 AppStamp:00000032
ModName: psiparser.ax ModVer: 0.1.0.0 ModStamp:495a69c8
fDebug: 0 Offset: 00001aa0

I think I'm totally up the creek now!
thanks for your help so far....
Suggestions? attached the latest set of logs
Thanks
Jim

[jocoman]

So far i really like GB-pvr. I just need to get over this hurdle that windows crashes when I do channel switching amongst digital channels only.
Thoughts someone.....
Thanks
See previous post with details
Jim

[sub]

Make sure you have the patches installed from the survival guide thread.