Setting Analogue Tuner Channel

[rwnz]

I'm unable to set the desired channel on my analogue tuner. I have a WinTV-HVR-2200 and NPVR 1.5.25. The DVB channels have set up fine but I have a cable STB with an analogue output fixed to 815.25MHZ = cable chan 332 = TV chan 64 which I wish to set the analogue part of tuner to. However when I go to Settings-Devices-Analog-Device Setup and add a channel e.g.:

• Number: a program number not used by any other program in NPVR e.g.100

• Name: I'm calling it "Cable"

• Input Source: Fixed Channel

• Country: New Zealand

• Tuning: Cable

• Fixed CH: 332

and hit OK it assigns Channel 72, not 332.

I also tried a similar thing with Input Source = Tuner and a seemingly random channel is assigned.

I had expected that I could edit the programming by double clicking on the channel but the only thing that can be changed is the Number.

I've attached some screen shots in the order that I've just described.

[martint123]

I've been here with the normal tuner rather than the fixed STB channel method.
If you double click on the line for "number" 100 in your last graphic, then the "number" can be edited. This then becomes the "tuner channel" when your OK it.

[rwnz]

So it does. It had to be simple. Thanks.

[martint123]

It had to be simple.

I didn't think it was when I first hit the problem