Banging my head against the wall (metaphorically)

[sub]

2010-11-02 16:19:06.953 VERBOSE FindFilterByName failed to locate filter: GB-PVR PSI Parser

Run ReRegisterFilter.bat and try again.

[Glynderi]

Tried that and imilne's suggestion earlier. Despite endless scanning, checking what's mapped, I can't find most channels in the TV guide.
I attach the latest logs as before.
Thanks

Robin

[sub]

So originally your problem was that you could not find any channels. Is that no longer the case no that you've re-registered the filters?

If that problem is gone, and its now just some channels missing, do a scan again (dont update the EPG), then post the config.exe.log and config.exe-native.log again.

[imilne]

Also remember that you're using GBPVR and not NPVR, so it won't find channels that aren't broadcasting at the time you do the scan (eg, BBC Three and BBC Four are only on air after 7pm). You will need to rescan several times at different times of day to eventually get them all.

[Glynderi]

Also remember that you're using GBPVR and not NPVR, so it won't find channels that aren't broadcasting at the time you do the scan (eg, BBC Three and BBC Four are only on air after 7pm). You will need to rescan several times at different times of day to eventually get them all.

Yes, I realise that.

[Glynderi]

Ok. I'll try that.

Thanks.

[Glynderi]

Done that. The box under the video box shows that the Digital channels scanned are all the ones I want. They just do not show in GB-PVR's Program Guide.

Logs attached.

Thanks

Robin

[sub]

Done that. The box under the video box shows that the Digital channels scanned are all the ones I want. They just do not show in GB-PVR's Program Guide.

What EPG source are you using?

[Glynderi]

DVB-EPG Broadcast

[sub]

Its been a really long time since I ran GBPVR, but from memory, when you setup a new capture source using the DVB EPG, and do a scan, all the channels found are listed in the lower right corner (which you indicate has all your channels?), and at the end of the scan the same channels are listed on the left with checkboxes. You need to tick each of those channels for them to be enabled.

If you've done that, but not all of the channels ticked show up in the TV Guide, and youre running Vista or Win7, then it might be Window's Virtual Store getting in the way.

Either way, if I was you, I'd move to NPVR. Its much better at scanning and managing channels.