Overscan

[BigMoose]

Out of interest, which CCC version are you using? Last time I upgraded it ballsed up overscan so I went back to some version from early 2010. I have it set to a small amount of overscan to avoid the crap on the SD broadcast channels and lump what I then lose on bluray playback. Would rather that than see the crap on SD channels.

[imilne]

Out of interest, which CCC version are you using? Last time I upgraded it ballsed up overscan so I went back to some version from early 2010.

Yeah, same here, although maybe not quite so old. I'd need to check (tonight). It's 11.4 at the very most, possibly even 11.2, and might even be a 10.x - it works, I get HD audio bitstreaming with TMT3, and I know how bad their drivers are, so I leave it well alone!

Iain

[Lao Pan]

I think they messed up overscan end of last year (I had a fix from a Mr mvallevand for a while) then they fixed it - then in 11.5 drivers they broke deinterlacing for H264 so I had to go back to 11.4 & again in 11.6 and 11.7 it was broke - but 11.8 seems the best yet (for my HD 5760 anyway)

But at least they got an extra 0.0001 fps in Return to Zog

[mulletback]

I'm running 10.8 - every driver/CCC release since then gives me a BSOD 1-2 times a day, on 3 different hardware platforms. I'm still running xpsp3, which I think AMD/ATI has given up on.

[hoborg]

@mulletback:
I doubt this is a drivers issue - make sure your GPU/system is not overheating...

[imilne]

Out of interest, which CCC version are you using?

Just checked, and I think it's 11.1 but it's hard to be sure. Apparently a simple "Help->About" that shows an easy to read CCC version is beyond their programming abilities.

[ATTACH=CONFIG]31774[/ATTACH]

Iain

[BigMoose]

Mine's 10.9 - as far as I can tell. I think it was around 11.3 I last tried it, it made an utter mess so I went back and haven't tried since. I've downloaded 11.8 though so will give that a go if it's OK.

[imilne]

Mine's 10.9 - as far as I can tell. I think it was around 11.3 I last tried it, it made an utter mess so I went back and haven't tried since. I've downloaded 11.8 though so will give that a go if it's OK.

Don't forget your best friend when it comes to trialling ATI drivers: System Restore

We got a bit sidetracked, but my original request still remains - I'd like a way of having similar zoom settings to what were available in GBPVR, ideally applied across the board regardless of aspect ratio mode (auto, fill, etc).

Code:

<HorizontalZoom>1.05</HorizontalZoom>
<VerticalZoom>1.03</VerticalZoom>

Iain