Multiple Audio Filters in Graphstudio

[BrianBlake]

HI , i hope you all can help me, i'm at a loss.

I have a NPVR setup which can now (using SAF codecs) watch all channels in Freeview in NZ so basically a mix of HD/SD. This part is working fine.

Recordings is another issue, if recorded from SD (MPEG) recordings can be watched fine. If recorded from HD the recording plays fine etc, but with no sound. This is basically on any channel containing an AC3 stream.

I've recorded a short snapshot and opened it in Graphstuido (after much forum reading this seemed to be a common tool) and it looks fine.

Video Stream --> FFDSHOW DXVA Video DECODER --> Enhanced Video Render
Audio Stream --> Lav --> Monogram AC3 --> Lav 001 --> Monogram AC3 --> Elecrard Audio Decoder --> Default WaveOut Device

Can anyone else see the problem here? I seem to have every AC3 filter triggered. If i delete all the audio filters and link the Audio out --> Default waveout it drops all the filters back in again.

Can anyone offer any advice on why this might be happening and how do i "re-map" the codecs?

Thanks
Brian

[Reddwarf]

What audio codec have you selected in nextpvr for ac3 audio? Have you tried ac3 filter?

[BrianBlake]

What audio codec have you selected in nextpvr for ac3 audio? Have you tried ac3 filter?

Yep that did the trick. Not sure why it didnt work when i previously had filter installed but hey ots workign so im not going to question it.

Loving this PVR, a great piece of work.

Thanks Sub.

Brian

[Reddwarf]

Loving this PVR, a great piece of work.

Thanks Sub.

Brian

Agreed!