2.4.3 Can't Playback some recordings on Clients

[sub]

See above, I discovered it will play again if I let it sit a few minutes.

I did see that. I cant explain it though, so I'm just having to look at the error that occurred when you were playing the second file (this 84 byte thingy).

[mvallevand]

I know that in MVP logs I see the short block all the time when Timing.Info is not used. In this example the "Seeking to:" time is a a factor of 188, but not the file on disk which is 5118361600

Code:

2012-03-25 19:44:55.471    [DEBUG][7]    Seeking to: 5118361476
2012-03-25 19:44:55.471    [DEBUG][7]    RollingFile.Seek(5118361476)
2012-03-25 19:44:55.472    [DEBUG][7]    RollingFile.Position returning 5118361476
2012-03-25 19:44:55.472    [DEBUG][7]    Reports as: 5118361476
2012-03-25 19:44:55.472    [DEBUG][7]    about to read 84600 from location 5118361476  (current length = 5118361600)
2012-03-25 19:44:55.473    [DEBUG][7]    Not all bytes read@2
2012-03-25 19:44:55.473    [DEBUG][7]    Read() didnt get all bytes. Got 124 of 84600 bytes requested.
2012-03-25 19:44:55.474    [DEBUG][7]    Seeking to: 5118276876

Martin

[sub]

I assume this is HDPVR again?

It may not be an issue on the MVP, but in his PC logs it was the last thing that happened before playback failed.

[smajor]

Okay, I did create a 200MB chunk of the recording from the beginning with cutchunk. Substituted it for the original and the same thing happened.

Unfortunately, I have no other devices to test other than the HDPVRs.

[smajor]

Just to cap this one, your patch here:

http://forums.nextpvr.com/showthread.php...post434584

Also fixed the last little bit on this problem where I couldn't play the same problem recording twice in a row without waiting a bit.