2012-11-22, 12:00 PM
Hi there!
This card supports the detection of DVB-T, DVB-T2 and DVB-C.
Previously there were 2 sets of Windows drivers that only allowed either DVB-T/DVB-T2 mode or DVB-C mode depending on which drivers were installed.
Recently a combined version of the drivers were released.
But I notice that NextPVR can only detect the card as DVB-T2 card and cannot tune to DVB-C signal. Is there any programming that needs to be done to tune both DVB-T/T2 and DVB-C on the single device as detected in NextPVR?
Thanks in advance.
This card supports the detection of DVB-T, DVB-T2 and DVB-C.
Previously there were 2 sets of Windows drivers that only allowed either DVB-T/DVB-T2 mode or DVB-C mode depending on which drivers were installed.
Recently a combined version of the drivers were released.
But I notice that NextPVR can only detect the card as DVB-T2 card and cannot tune to DVB-C signal. Is there any programming that needs to be done to tune both DVB-T/T2 and DVB-C on the single device as detected in NextPVR?
Thanks in advance.