PostupdateEPG

[Tre4Bax]

Hi There,

So this morning I came down to no info in my EPG. Last week I stopped running a separate timer to initialise EPGCollector and put it in PostUpdateEPG. Long and short is I am not sure whether PostUpdateEPG is actually running (so I've added some echos into the batch file) but wondered if there is somewhere in a log I can check this.

Also I realised that I would probably be better updating this before the EPG loads but can't find references to a PreUpdateEPG.bat does this exists?

Trevor

[Lao Pan]

You need to run EPGCollector from UpdateEPG.bat - not PostUpdateEPG.bat that runs After the EPG has been updated

[Tre4Bax]

Many thanks, I'll leave my echos in there to check it is working :-)