EPG update incomplete

[newyankee]

Since removing one of my two identical tuners (Hauppauge 5500, defective) DVB-EPG is not working properly anymore. As far as I can see, the EPG source is wrong. I have exported the channel list and imported it again, however, that didn't help. Do I need a full rescan?

Logs attached.

Thanks

[Reddwarf]

Since removing one of my two identical tuners (Hauppauge 5500, defective) DVB-EPG is not working properly anymore. As far as I can see, the EPG source is wrong. I have exported the channel list and imported it again, however, that didn't help. Do I need a full rescan?

Logs attached.

Thanks

Probable needs to set up the epg source again.

[newyankee]

Probable needs to set up the epg source again.

Didn't mention, tried that, no change. Probably would have been too easy....

[Graham]

Since removing one of my two identical tuners

I see this in the logs

2014-06-29 09:01:39.261 [ERROR][7] Channel uses broadcast EPG connected to non-existant capture source: 20 (channel: tagesschau24 HD)

I suspect that your tuner device configuration has become tangled. If it were me ... I would delete all tuner devices and all channels, re-boot to force all NextPVR componenets to pick up the new empty device config and then re-add the tuner.

[Reddwarf]

I see this in the logs



I suspect that your tuner device configuration has become tangled. If it were me ... I would delete all tuner devices and all channels, re-boot to force all NextPVR componenets to pick up the new empty device config and then re-add the tuner.

Yeah, the problem is that if you remove a tuner, all references to that tuner does not go away autimatically, best way is to delete all channels from that tuner before deleting the tuner itself.