NextPVR doesn't load EPG for all channels

[Tolo]

Hello,

I'm having an issue with NextPVR. It loads EPG for most channels but it has problems with loading from one tv multiplex at 674 MHz in Poland.
Please take a look at the logs.

I've seen one thing that makes me wonder, is it ok?
2015-01-22 11:14:28.168 [DEBUG][7] No C:\Users\Public\NPVR\Scripts\UpdateEPG.bat file found

When I was installing NextPVR there was NRecord.exe INSTALL crash, but the rest of the setup went ok.

Please help me or tell me which are good free alternatives to NextPVR if the problem couldn't be solved.

[sub]

Hello,

I'm having an issue with NextPVR. It loads EPG for most channels but it has problems with loading from one tv multiplex at 674 MHz in Poland.
Please take a look at the logs.

You'll probably need to use a tool like TSCapture to capture a 1 minute full transport stream recording of 674MHz, and make the file available somewhere for me to download, so I can try reproducing the problem here.

I've seen one thing that makes me wonder, is it ok?
2015-01-22 11:14:28.168 [DEBUG][7] No C:\Users\Public\NPVR\Scripts\UpdateEPG.bat file found

You can ignore this. You wouldn't have one of these by default. You'd only create one if your using an XMLTV epg.

[dumbest]

When I was installing NextPVR there was NRecord.exe INSTALL crash, but the rest of the setup went ok.

You are not alone.
3.3.8 Nrecord.exe always crash for me during installation, even on a newly installed Windows 7 x64 (fully updated).
NPVR will then continue to complete the installation after the error and everything appears to be working fine.

But stopping NPVR and starting NPVR again will result in the 2nd error (bottom pic).
Start it again and it will start up normally.
And this error won't happen again until the next bootup/reboot.

Something similar here : http://forums.nextpvr.com/showthread.php...on-t-start

[sub]

dumbest, if you run "nrecord.exe INSTALL", from the command line, do you get this same stack overflow error message?

[dumbest]

dumbest, if you run "nrecord.exe INSTALL", from the command line, do you get this same stack overflow error message?

Hi sub,

No error.

[sub]

Ok, thanks for checking. Pity it didn't cause the error again - might have helped track down the cause. At this stage I'm not sure what could have accounted for that original error.

[Tolo]

OK, I have captured 1 minute from this frequency.
http://www42.zippyshare.com/v/U7Paomnt/file.html

Other DVB software and real TV loads EPG from these channels with no problems.