FreeNAS emby issue with NextPVR base URL for Ceton 6 Eth

[marcisikoff]

Hey I've got FreeNAS going with all my content and have the Emby plugin which works fine.

Emby supports live TV, but I was told my Ceton 6 Eth device would only be supported by NextPVR.

Problem I have is the plugin for NextPVR asks only for these fields:

NextPVR base URL as http://{hostname}:{port}

-and-

NextPVR pin which is set to 0000

Problem is I have no idea what to put into the base URL:port as I've tried my Ceton's IP address to no luck and tried a tuner's RPC IP address:port with no luck too.

Anyone have any luck getting something working?

[Graham]

Is NextPVR installed and running?

Can you record and watch Live TV in NextPVR? It's probably easiest to get everything working using just NextPVR and then try and connect using emby.

[mvallevand]

Hey I've got FreeNAS going with all my content and have the Emby plugin which works fine.

Emby supports live TV, but I was told my Ceton 6 Eth device would only be supported by NextPVR.

I don't know if the Ceton's support http streaming in IPTV mode. If not and you want to use the Network Recorder plugin with SageDCT too http://www.nextpvr.com/nwiki/pmwiki.php?...extPVR.pdf (same instructions for the Ceton DCR). The IP is the IP of where you run SageDCT

Martin