2020-08-22, 08:42 AM
Hello sub,
i installed NPVR for a friend. He uses SAT.
There is strange behavior when we do a channel scan. The frequencies are scanned. (i edited the list time ago, and you integrated it - Astra 19.2).
The list is correct, i can see that when a frequencies is scanned, the correct number of channels is found. But after the scan has finished a lot of channels are missing. It is not a problem with the selection of free and encrypted channels, they are just missing. It also happens that some station of a frequency are found, and some are missing.
I think this is a bug. The reception perfekt, so no critical signal.
I tried to edit the list, leaving only one (or two or three) frequencys, save it under a new name, with new description, did a scan of that "satellite" -> channels found and added.
But its hard to do this with a lot of transponders.
I think about two possible problems:
- The scan is to fast, so that the channels are not registered to the database (the number of channels is correct if i check during the scan, so they are scanned, but missing afterwards).
- There is perhaps a general problem in the process while scanning the satellite (creating the list, or something like that).
Would be great if you can look into that.
i installed NPVR for a friend. He uses SAT.
There is strange behavior when we do a channel scan. The frequencies are scanned. (i edited the list time ago, and you integrated it - Astra 19.2).
The list is correct, i can see that when a frequencies is scanned, the correct number of channels is found. But after the scan has finished a lot of channels are missing. It is not a problem with the selection of free and encrypted channels, they are just missing. It also happens that some station of a frequency are found, and some are missing.
I think this is a bug. The reception perfekt, so no critical signal.
I tried to edit the list, leaving only one (or two or three) frequencys, save it under a new name, with new description, did a scan of that "satellite" -> channels found and added.
But its hard to do this with a lot of transponders.
I think about two possible problems:
- The scan is to fast, so that the channels are not registered to the database (the number of channels is correct if i check during the scan, so they are scanned, but missing afterwards).
- There is perhaps a general problem in the process while scanning the satellite (creating the list, or something like that).
Would be great if you can look into that.