V5 merging channels after scan.

[biggoronjon]

I have two stations that use the exact same channel numbers.  On V4 it would list all the channels after the scan and I could manually edit the list.  Or I could do a manual scan by frequency.  With V5 it is hiding one of the stations and I cannot fix it in the setup.  Is there any plan to add manual scanning back to V5?

[biggoronjon]

Temporary fix- I disconnected the aerial immediately after the hidden channel was detected and was able to add it.

[mvallevand]

It sounds like there is an initial with the way v5 creates the list not with the scan itself. Best bet is to send in your zipped logs following a scan so sub can see which tuner type you are talking about.

An alternative I used successfully in v4 for a similar problem was to create an individual tuning file for the frequency with the "missing" station.

Martin

[biggoronjon]

Fresh install logs. Scans 49 channels but returns 45 channels. 
BDA Compatibility Mode set on MediaPortal

[mvallevand]

Sub should be able to work this that the 4 duplicates all show ie.

2020-09-09 11:55:19.608 [DEBUG][37] new channel: ION (<tuning> <type>ATSC</type> <locator> <physical_channel>11</physical_channel> </locator> <service_id>2</service_id> <tsid>2599</tsid> <service_type>1</service_type></tuning>)

2020-09-09 11:56:37.062 [DEBUG][37] new channel: ION (<tuning> <type>ATSC</type> <locator> <physical_channel>25</physical_channel> </locator> <service_id>8</service_id> <tsid>1789</tsid> <service_type>1</service_type></tuning>)


Note with the last two firmware updates you can use NextPVR as the BDA Mode. Also no point in scanning above 33 for OTA ATSC anymore.

Martin