Difficulty in Changing Channels

[jaydub222]

My setup is:
Win10
Colossus II tuner
Hauppauge IRblaster applet
Hauppauge WinTV v10
Schedules Direct for EPG
DirecTV for tuner
NextPVR 5.0.9

I'm currently using WinTV.  I downloaded NextPVR to try something different; I have it pretty much set up and TV Guide is fully populated with listings.  However, I'm unable to change channels, from either TV Guide or by right clicking the mouse and bringing up "Channels'.  When I select a channel, no pulses are seen coming from the IR emitter.  Hauppage's IRblast applet is installed and the blaster is properly connected to Colossus and the STB, and channel changing works fine in WinTV.  Is there something special I need to do to get the blaster to work in NextPVR?

[sub]

If you click on the device in the settings page, and you see the list of channels, do you see the selected blaster listed next to each channel? If not, you likely didn't add the blaster when you setup the channels.

[jaydub222]

Thanks for the advice. I re-configured and everything is up and running. Many, many thanks Mr. Administrator.